Filter
Top Products
Page 37 of 47
4.
If you have an IBM system with PS1TOOLS installed, check your AUTOEXEC.BAT for the
following statement. If the statement is included in your AUTOEXEC.BAT, move it to the
end of the file so that it is the last statement executed. All Mwave statements that were added
to the AUTOEXEC.BAT during the Multimedia Modem Plus installation must be executed
before this statement:
C:\PS1TOOLS\PS1START.BAT
5.
If you have a sound card in your system along with the Multimedia Modem Plus and are
experiencing any difficulties with Multimedia Modem Plus functions, remove the additional
sound card and use the Multimedia Modem Plus as your sound card. This will also free up
an additional slot in your computer. Make sure to remove or comment out all statements in
your CONFIG.SYS and AUTOEXEC.BAT that were added when the sound card was
installed. (See your sound card's user manual for information about statements that are added
during installation.)
6.
If you have installed the Microsoft Mouse Driver and the Microsoft InPort Bus Mouse you
may receive the following error message when the Multimedia Modem Plus board is installed
and the system attempts to load the mouse driver during the boot sequence:
Interrupt jumper missing
Use of the Microsoft InPort (BUS) mouse on IRQ 2 in Microsoft Windows causes the
mouse to not function correctly in both standard and enhanced modes on AT class
machines due to an interrupt conflict.
Try the following steps to resolve the problem:
a.
Run the CONFIG.EXE program and choose Automatic Setup & Test to let the program
automatically find a configuration which eliminates a possible conflict between the bus
mouse and the Multimedia Modem Plus board.
b.
If all tests pass, exit and save the new configuration, reboot your machine and see if the
message goes away.
c.
If the problem persists, try changing the bus mouse IRQ jumper to 5 (or 3 or 4) to
eliminate the conflict. Then repeat steps (a) and (b) to reconfigure your Multimedia
Modem Plus board and reboot your system.
IRQ 2 is unavailable to add-in cards on IBM PC/AT bus class computers due to the fact
that IRQ 2 cascades to IRQ 9 on the second Intel 8259 PIC chip.
7.
Manually setting the DSP DMA and Sound Blaster DMA to the same setting in CONFIG or
CONFIGO will cause a system hang.