IBM 8317 Personal Computer User Manual


 
Chapter 2. Using the IBM Setup Utility
The IBM Setup Utility program is stored in the electrically erasable programmable
read-only memory (EEPROM) of your computer. The IBM Setup Utility program is
used to view and change the configuration settings of your computer, regardless of
which operating system you are using. However, the operating-system settings
might override any similar settings in the IBM Setup Utility program.
Starting the IBM Setup Utility program
To start the IBM Setup Utility program, do the following:
1. If your computer is already on when you start this procedure, shut down the
operating system and turn off the computer.
2. Turn on your computer and look for the following prompt on the logo screen:
(To interrupt normal startup, press Enter)
Press Enter when you see the prompt. The Startup Interrupt Menu is displayed.
3. Press F1 to start the IBM Setup Utility.
Note: If a user password is set, you must type the password to continue. If an
administrator password has been set, you cannot make any changes to
configuration using the IBM Setup Utility program until you type your
administrator password. See “Using passwords” on page 22 for more
information.
The IBM Setup Utility might start automatically when POST detects that hardware
has been removed or new hardware has been installed in your computer. A sample
of the first IBM Setup Utility screen is shown here.
[13:34:25]
[08/30/2002]
682611x
28KTxxAUS
28xxA
IBM
1234567
08/30/02
Viewing and changing settings
The IBM Setup Utility program menu lists items that identify system configuration
topics.
© Copyright IBM Corp. 2002 21