IBM 8490 Server User Manual


 
Major components of the xSeries 206m Types 8485 and 8490
Blue on a component indicates touch points, where you can grip the component to
remove it from or install it in the server, open or close a latch, and so on.
Orange on a component or an orange label on or near a component indicates that
the component can be hot-swapped, which means that if the server and operating
system support hot-swap capability, you can remove or install the component while
the server is running. (Orange can also indicate touch points on hot-swap
components.) See the instructions for removing or installing a specific hot-swap
component for any additional procedures that you might have to perform before you
remove or install the component.
The following illustration shows the major components in the server.
Note: The illustrations in this document might differ slightly from your hardware.
Front adapter-
support bracket
Drive cage
EMC shields
Filler
panels
Cover
System board
Upper
bezel
Lower
bezel
Microprocessor
Heat sink
Power supply
DIMM
PCI-X expansion card
SATA
hard disk drive
(some models)
Hot-swap
hard disk drive
(some models)
SATA filler panel
SAS filler panel
Mini-PCI-X adapter
(SAS/SATA controller)
Fan
6 xSeries 206m Types 8485 and 8490: Installation Guide