Filter
Top Products
7
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Setup Diskette for Windows 2000
This section must be
completed before
continuing with the
Windows 2000
confguring
for your monitor.
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Flat Panel Monitor Installation diskette.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows 2000.
4. Open the
D
ISPLAY
P
ROPERTIES
window by clicking on
S
TART
,
S
ETTINGS
,
C
ONTROL
P
ANEL
and then double clicking on the
D
ISPLAY
icon.
5. Select the
S
ETTINGS
tab.
6. Select the
A
DVANCED
button.
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends using
either 1024 x 768 at a refresh
rate of 60Hz.
7. Select the
M
ONITOR
tab.
8. Select the
P
ROPERTIFS
button.
9. Select the Driver
tab.
10. Open the Upgrade Device Driver Wizard window by clicking on
UPDATE DRIVER and then select the NEXT button.
11. select the “Display a list of the known dirvers for this device so that lcan
choose a specifc driver” and then sefect the NEXT button.
12. Inset the Setup diskette into drive A: and select the HAVE DISK button.
13. select OK.
14. Choose
IBM T50
monitor and select
OK
. The files will be copied from the
diskette to your hard drive.
15. Close all open windows and remove the diskette.
16. Reboot the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
T50_setup.fm Page 7 Thursday, August 9, 2001 11:09 AM