IBM R61E Laptop User Manual


 
1170 System board, PC Card/ExpressCard (or PC Card/Smart
Card) slots assembly
For access, remove these FRUs, in order:
v “1010 Battery pack” on page 64
v “1020 Ultrabay Enhanced device for R61 and R61i” on page 65
v “1030 Hard disk drive cover, hard disk drive, and hard disk rubber rails” on
page 66
v “1040 Palm rest or palm rest with fingerprint reader” on page 68
v “1060 Keyboard” on page 72
v “1070 Optical drive for R61e and R61i” on page 74
v “1080 Modem daughter card (MDC-1.5)” on page 75
v “1090 PCI Express Mini Card for wireless LAN” on page 77
v “1110 Keyboard bezel and speakers” on page 80
v “1120 Fan assembly” on page 83
v “1140 LCD assembly” on page 87
v “1150 Base cover, USB sub card with cable, and PC Card/ExpressCard (or PC
Card/Smart Card) bezel assembly” on page 90
v “1160 Structure frame and IEEE 1394 sub card” on page 96
Important notices for handling the system board:
When
handling the system board, bear the following in mind.
v At every point in the process, be sure not to drop or stack the system board.
v The system board has an accelerometer, which can be broken by applying
several thousands of G-forces.
Note: Dropping a system board from a height of as little as 6 inches so that it
falls flat on a hard bench can subject the accelerometer to as much as 6,000 G’s
of shock.
v Be careful not to drop the system board on a bench top that has a hard
surface, such as metal, wood, or composite.
v If a system board is dropped, you must test it, using PC-Doctor for DOS, to
make sure that the HDD Active Protection still functions (see below).
Note: If the test shows that HDD Active Protection is not functioning, be sure
to document the drop in any reject report, and replace the system board.
v Avoid rough handling of any kind.
v If you put a system board down, be sure to put it only on a padded surface
such as an ESD mat or conductive corrugated material.
After
replacing the system board, run PC-Doctor for DOS to make sure that
HDD Active Protection still functions. The procedure is as follows:
1. Place the computer on a horizontal surface.
2. Run Diagnostics --> ThinkPad Devices --> HDD Active Protection Test.
Attention: Do not apply physical shock to the computer while the test is
running.
R61, R61e, and R61i (15.4-inch widescreen) 101