Filter
Top Products
3
Getting Started
Thank you for purchasing the iHome iH41 Flip Alarm Clock Radio for your iPod. Designed specifically to work
with your iPod Touch, this system provides high quality audio performance and lets you enjoy videos in
horizontal view.
Please read this instruction carefully before the appliance is operated and keep it for future reference.
Install iPod Insert
Your iH41 comes with four inserts to ensure your iPod fits properly in the dock.
To place an insert:
1. Select the insert for your iPod. (see table on page 1)
2. Gently press the iPod insert into the dock.
3. Carefully place your iPod into the dock. The iPod must not be in a case or “skin”.
Install AC Adaptor
Connect the AC adaptor cable plug into the jack on the back of the system, then plug the AC adaptor into the
wall outlet.
Install/Replace backup Battery
The iH41 uses a CR2032 battery for backup battery system to provide continuous alarm operation and clock
settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the
AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time
settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings.
1. Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery
replacement.
2. Open backup battery compartment door located on the back of the unit.
3. Insert a new CR2032 battery, checking that the polarity (+ and – ends of the battery) matches the drawing
near the battery compartment. Close the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).