Filter
Top Products
ENGLISH
F
1) Adjust the H-POSITION so that the left side of the picture frame will move to the left
edge of the display area.
NOTE n When the left side of the picture frame moves apart from the left edge of the display area
during the COARSE adjustment, adjust steps 1) and 2).
n Another way to make the COARSE adjustment is to correct the vertical wavy lines in the
zebra pattern.
n The picture may flicker during the COARSE, H-POSITION and V-POSITION adjustment.
n In case the picture frame is bigger or smaller than the data display area after the COARSE
adjustment, repeat steps from
C
.
2) Stretch the right side of the picture frame to the right edge of the display area by
adjusting the COARSE in IMAGE SET-UP.
C
Select AUTO in IMAGE SET-UP and perform the Automatic set-up.
Or press the and Buttons at the same time when the Menu is not displayed.
(Direct adjustment)
D
Adjust the image manually by following procedure below when the screen has a flicker or
blur, or the picture does not fit in the display area after performing the Automatic set-up.
E
Adjust the V-POSITION so that the top and bottom of the picture frame will fit to the
display area.
OPERATING THE MONITOR 15