Filter
Top Products
ENGLISH
6 BEFORE YOU OPERATE THE MONITOR
CONNECTING YOUR MONITOR
[Example of Connection]
A
Ensure that both the computer and the monitor are switched off.
B
Connect the computer to the monitor with the signal cable. (See page 20 for CONNECTOR PIN
ASSIGNMENT.)
C
Connect the Power Cable to the monitor first and then to the power supply.
NOTE n The signal cables used for connecting the computer and monitor vary by the type of computer
used. An incorrect connection may cause serious damage to both the monitor and the
computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a
special cable is required please contact your local iiyama dealer or regional iiyama office.
n For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
n Make sure you tighten the finger screws at each end of the signal cable.
n Cables can be bundled together inside the cover at the back of the stand. See next page
for cable wiring.
Power Cable (Accessory)
to D-Sub connector
of computer
Computer
to DVI connector
of computer
< Back >
D-Sub Signal Cable
(Accessory)
DVI-D Signal Cable
(Accessory)