Filter
Top Products
ENGLISH
BEFORE YOU OPERATE THE MONITOR 5
Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.
Do not give a strong impact to the monitor. It may cause damage.
Unplug the monitor before removal or installation to avoid electric shock or damage.
The monitor is supplied complete with a stand-base. If you prefer to wall mount the monitor, please
follow the instructions below to remove the stand-base. Be sure to include the stand with the monitor
if it is necessary to return the unit.
CAUTION
FITTING AND REMOVAL OF BASE : ProLite B1706S
<Installation>
A
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
B
Install the Stand-Base to the Monitor.
C
Fix the Monitor with the Stand by the screw fi rmly, and the knob of the screw push down.
<Remove>
A
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
B
Pull up the knob of the screws, and remove the screw and the Stand-Base.
<Stopper pin>
Please stand the monitor and then remove the
stopper pin on the back of the stand slowly while
pushing top face of the stand before you install the
monitor. Careful attention is required as the monitor
is sprung loaded and may expand quickly when
removing it.
Stopper pin
Stand-Base
Screw for
Stand-Base fixing
Push-down knob