Filter
Top Products
6
When the McPC 10/100 is in one of the Force modes, enable LFD by setting
5
to the
ON
position. Disable LFD by resetting
5
to its default,
OFF
, position. In order for
LFD to function properly, Force mode must be enabled by setting
7
to
ON
with
either
8
ON
for 10 Mbps or
8
OFF
for100 Mbps.
NOTE
6
must also be
ON
when enabling LFD.
LFD On Positions for 10 Mbps
LFD On Positions for 100 Mbps
NOTE
When using the LFD feature, if the DIP Switches are in any other combination than
listed above, the module may exhibit erratic behavior.
Twisted Pair Crossover/Pass-Through Button (PCI Version)
The McPC 10/100 features a crossover/pass-through button, located on the faceplate
next to the RJ-45 connector, to set the twisted pair connection type. Select a pass-
through connection by pressing the button. A crossover connection is selected when
the button is
OUT
. If it is not known which connection is needed, set the button to
whatever setting makes the twisted pair LNK (link) LED glow.
Crossover/Pass-Through Switch