Filter
Top Products
Turn on projector and source
1
Connect the power cord to the projector
and to an electrical outlet
The power light on the projector will light blue.
2
Turn on the projector
Press power (on the projector or remote).
The power light will light blue.
3
Wait for the lamp to warm up
It will take a minute for the lamp to reach full brightness.
Warning:
Do not look directly into the lens while the
projector is being used.
4
Turn on computer or other source
You may need to press a speci c key combination to activate
your laptop's external video port. On most laptops, hold
down the FN key while pressing a key labeled CRT/LCD, LCD/
VGA, a monitor icon , or similar. Key combos for popular
models:
Apple F7 HP/Compaq Fn+F4 or Fn+F6 Sony Fn+F7
Dell Fn+F8 IBM ThinkPad Fn+F7 Toshiba Fn+F5
Fujitsu Fn+F10
Complete laptop activation chart at www.infocus.com/support
Important:
If there is still no video, restart your
computer ( rst make sure it's connected to the
projector and the projector is turned on).
5
Change source if needed
If needed, press
SOURCE
(on the projector or remote), use
and to highlight the desired source, and press the
on the projector (or
SELECT
on the remote) to choose a
different source.
i
5-10 sec.
4