Filter
Top Products
10
Command Control via the Network
When the projector is connected to the network, the projector can be controlled
with RS-232 commands from the computer with a web browser.
For RS-232 command information, refer to the RS-232 Communication / Network
command table
(&16).
Connection
1.
Turn off the projector and the computer.
2.
Connect the projector's LAN port and the computer's LAN port with a LAN
cable. Use the cable that fullls the specication shown in gure (Use CAT-5
or greater LAN Cable when LAN ports are used )
3.
Turn the computer on, and after the computer has started up, turn the
projector on.
Command Control via the Network
LAN
LAN
LAN cable (CAT-5 or greater)