Filter
Top Products
– 47 –
LED Error Messages
Error Code Messages
PWR LED
TEMP LED
READY LED
Overheating
Off
Solid Red
Off
Thermal break
Flashing Red 4x
Off
Off
Lamp strike fail
Flashing Red 5x
Off
Flashing Red 1x
Lamp Short circuit in output detected
Flashing Red 5x
Off
Flashing Red 2x
Lamp End of lamp life detected
Flashing Red 5x
Off
Flashing Red 3x
Lamp did not ignite
Flashing Red 5x
Off
Flashing Red 4x
Fan 1 error
Flashing Red 6x
Off
Flashing Red 1x
Fan 2 error
Flashing Red 6x
Off
Flashing Red 2x
Fan 3 error
Flashing Red 6x
Off
Flashing Red 3x
Fan 4 error
Flashing Red 6x
Off
Flashing Red 4x
Case open
Flashing Red 7x
Off
Off
DMD fail
Flashing Red 8x
Off
Off
Color wheel fail
Flashing Red 9x
Off
Off
Ballast Communication fail
Flashing Red 5x
Off
Flashing Red 10x
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before
restarting the projector. If the PWR or READY LED is still blinking or the TEMP LED is lit, contact
InFocus Technical Support at www.infocus.com/support.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
3. Many laptops do not automatically turn on their external video port when a projector is
connected. Usually a key combination like FN + F8 or CRT/LCD key turns the external
display on and off. Locate a function key labeled CRT/LCD or function key with a monitor
symbol. Press FN and the labeled function key simultaneously.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the projection range. (Within 7m/23' for
the standard lens; within 20m/66' for the long lens and within 3m/10' for the short lens).
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone buttons on the remote control or projector to correct the problem.