Filter
Top Products
IN8606HD User’s Manual
–42 –
LED Error Messages
ERROR CODE MESSAGES
POWER LED
BLUE
LAMP LED
RED
System initialization
Flashing OFF
Ready to power on (Standby)
ON OFF
System powering up
Flashing OFF
Lamp lit, normal operation
ON OFF
Cooling
Flashing OFF
Overheating
3 blinks OFF
Thermal break sensor error
4 blinks OFF
Lamp failure
5 blinks ON
Lamp temperature shut down
5 blinks 1 blink
Short circuit in lamp output detected
5 blinks 2 blinks
End of lamp life detected
5 blinks 3 blinks
Lamp did not ignite
5 blinks 4 blinks
Lamp extinguished during normal operation
5 blinks 5 blinks
Lamp extinguished during power-up phase
5 blinks 6 blinks
Lamp voltage error
5 blinks 7 blinks
Lamp ballast error
5 blinks 8 blinks
Ballast watt value is out of range
(Lamp Normal & Eco mode)
5 blinks 9 blinks
Lamp ballast communication error
5 blinks 10 blinks
Fan-1 error
6 blinks 1 blink
Fan-2 error
6 blinks 2 blinks
Fan-3 error
6 blinks 3 blinks
The projector case is open
7 blinks OFF
DAD1000 error
8 blinks OFF
Color wheel error
9 blinks OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above
, please contact InFocus Support.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all the equipment and power everything up again. The projector should be turned
on last.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.