Filter
Top Products
5
Connector Panel
The projector provides eight discreet video connectors:
• two red-green-blue RCA (SD/ED/HD component)
•two S-video
•one composite RCA
• one M1-DA (HD, RGBHV, HD component, DVI, and computer)
• one VESA (HD, RGBHV, HD component, and computer)
• one D5 (SD/ED/HD component, RGB SCART)
It also has a mini-jack input for a Niles or Xantech-compatible IR repeater
and an RS-232 connector for serial control. The Command Line Interface
(CLI) specifications and commands are listed in the Appendix starting on
page 37.
Two 3.5mm mini-jack triggers provide 12 volt current. Trigger 1 provides a
constant output while the projector is on. For example, if you connect your
projection screen to Trigger 1, when you turn on the projector the screen will
move down; when you turn the projector off, the screen will return to the
storage position. Trigger 2 provides a 4:3 aspect trigger. When you select 4:3
in the Aspect Ratio menu or from the Resize button on the remote, a 12v
signal will be sent after a five second delay. Use this trigger for screens with
4:3 aspect curtains. When you switch back to 16:9 format, the curtains open
to reveal the entire screen.
For details on each connector type and their inputs, see page 35.
.
IR in
1
2
YY
Pr Pr
Pb Pb
serial control
M1-DA
vesa
trigger 1
8
2
1
3
4
6
5
7
trigger 2
component
s-video
video
D5
component
lock
remote control
receiver (IR)
power
connector
s-video
video
component
video
video/computer
1 & 2
serial
connector
D5
video
IR input
12v triggers
3.5mm mono plug for
+12v
ground
to screen relay (see screen manufacturer
for details)
12 volt current
connection