Filter
Top Products
4
Connector Panel
The projector provides eight discreet video connectors:
•two component RCA
•two S-video
•one composite RCA
• one M1-DA (HD, DVI, and computer)
• one VESA (HD, HD component, and computer)
•one component D5
It also has a mini-jack input for a Niles or Xantech-compatible IR repeater
and an RS-232 connector for serial control. The Command Line Interface
(CLI) specifications and commands are listed in the Appendix starting on
page 36.
Two 3.5 mm mini-jack triggers provide 12 volt current. Trigger 1 provides a
constant output while the projector is on. If you connect your projection
screen to Trigger 1, when you turn on the projector the screen will move
down; when you turn the projector off, the screen will return to the storage
position. Trigger 2 provides a 4:3 aspect trigger. When you select 4:3 in the
Aspect Ratio menu or from the Resize button on the remote, a 12v signal
will be sent after a three second delay. Use this trigger for screens with 4:3
aspect curtains. When you switch back to 16:9 format, the curtains open to
reveal the entire screen.
For details on each connector type and their inputs, see page 34.
IR in
1
2
YY
Pr Pr
Pb Pb
serial control
M1-DA
vesa
trigger 1
8
2
1
3
4
6
5
7
trigger 2
component
s-video
video
D5
component
lock
remote control
receiver (IR)
power
connector
s-video
video
component
video
video/computer
1 & 2
serial
connector
D5
video
IR input
12v triggers
screen trigger connection
3.5mm mono plug
+12v
ground
to screen relay (see screen manufacturer
for details)