Filter
Top Products
(4) Solid structure
mountin
g
p
oints
(2) Cable access points
(2) Tension knobs
Screen side
(
Yellow indicator
)
Clamp plate
Safety knobs
(
Red indicator
)
Ceiling plate
Tools Needed for Installing the Digital Projector Mount
You need the following tools to install the Digital Projector Mount:
• Phillips head screwdriver (not included)
• Allen wrench (included)
• Drill (for installation environment only -
do not use a drill on the Digital Projector or the Digital Projector
Mount) and drill bit to match the hardware for your installation environment (not included)
• The commercially available hardware (E) that is required by your installation environment (not included)
Getting the projector ready
Before you start the installation process, prepare your Digital Projector by performing the following steps
(F
IGURE 1).
1. Turn the projector (C) upside down and place it on a clean flat surface, preferably on a towel.
2. Locate the mounting bracket (B) and align it over the holes on the projector.
3. Locate the four (4) 6 (mm) x 10 (mm) Phillips head screws (A).
4. Use the Phillips head screwdriver to secure the mounting bracket (B) to the projector via the three
(3) Phillips head screws (A). Do not over-tighten the screws.
F
IGURE
1
A
C
B
(Optional) Fixed Height Ceiling Installation
Complete the following steps to install the projector mount and projector on your ceiling. This installation
works best with low ceilings (F
IGURE 2).
Note: Look at the bottom of the mount assembly (D) and locate the arrow. Make sure you install the projector
mount with the arrow pointing toward your screen.
1. Remove the upper plate from the assembly (D) secure to the ceiling structure using the commercially
available hardware (E) suitable for your environment. Be sure that the mount assembly screen indicator
arrow is pointing toward your screen.
2. Replace the mount assembly with the upper plate and fully raise the safety knob and tension knobs all
the way. Carefully raise the projector (C) with the mounting bracket (B) attached and insert it into the
bottom of the mount assembly (D) by its tabs.
3. Rotate the projector (C) with the mounting bracket (B) attached 180º
so that the projector’s focus ring
is pointing toward your screen.
4. Align the safety knob on the mount assembly (D) with the end of the arrow-shaped slot on the mounting
bracket (B) and screw it through the opening to prevent further rotation. Hand-tighten the safety knob.
5. Hand-tighten the remaining two tension knobs to secure the mounting bracket (B) to the mount
assembly (D).
CAUTION: Check all of the hardware for proper tightness and security. Do not over-tighten the screws.
Lightmount Plus® Overview
Lower assembly
2
(3) Single wood stud
mountin
g
p
oints
A
djustable
extension