Filter
Top Products
34
English ...
Appendices
Warning: To avoid
burns,allowtheprojec-
tor to cool for at least
60 minutes before you
replace the lamp!
Warning: To reduce the
riskofpersonalinjury,
do not drop the lamp
module or touch the
lamp bulb. The bulb
may shatter and cause
injury if it is dropped.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power/
Standby .
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screw from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module and pull up
the lamp bar.
7. Pull out the lamp module by force.
To replace the lamp module, reverse the previous steps.
1
3
4
2