Filter
Top Products
BLOW5/BLOW5D User’s Manual
11
4. CONNECTION
4.1. POWERING UP
IMPORTANT NOTE
All connections should be made, And faders, volumes, sensitivity and other controls are at minimum levels.
Before powering up the BLOW5 speakers, all other equipment should be turned on first.
Please make sure that the unit is plugged into the correct voltage.
The power switch is located on the rear panel.
Turn on the power to the BLOW5.
The unit is equipped with a protection circuit, an interval of a few seconds is required before the unit will
operate normally.
4.2. ANALOG AUDIO INPUT
Connect the male side of an XLR balanced cable to the XLR input or TRS balanced (or unbalanced) cable
to the TRS input of the rear panel.
Input Select Switch should be set to analog input.
Refer to the following diagram.
< Connecting of Analog XLR balanced cable >
< Connecting of TRS Analog balanced/unbalanced cable >
T
RS balanced cable
T
RS unbalanced cable
XL
R
balanced cable