Filter
Top Products
Installation Guide for the Intel Server Control 17
Installing Linux DMI Service Provider
1. InserttheSoftwareKitCDintotheLinuxserverCDROMreader.
2. Mount the CD using either of the following methods:
• Enter the mount command as follows:
mount /mnt/cdrom
• Use the Disk Management utility. To invoke this utility click the Start button, select
System, and then select the Disk Management menu option.
3. Uninstall ucd-snmp if it has been installed previously with
rpm –e.
✏
NOTE
If you uninstall ucd-snmp, you must also remove all related snmp and
DMI packages. When you remove these packages, remove them in an
order that eliminates dependency error messages. For example, if a
dependency error message appears, remove the package mentioned in
the error message. Continue removing the dependent packages in this
manner until the error messages stop.
4. Install the DMI service provider package located in the \Software\Linux\dmisnmp directory on
the Software Kit CD by using the rpm command. For example, the following command installs
a version of the DMI service provider package:
rpm –i dmisp-1.0-6.i386.rpm
5. Locate and install the ucd-snmp RPM, ucd-snmp-utils RPM, and dmi2snmp RPM packages.
These packages are also located in the \Software\Linux\dmisnmp directory on the Software Kit
CD. Use the rpm command to install each package. For example, the following three
commands install versions of these three packages:
rpm –i ucd-snmp-4.1.1-15smux.i386.rpm
rpm –i ucd-snmp-utils-4.1.1-15smux.i386.rpm
rpm –i dmi2snmp-1.0-15.i386.rpm
6. Reboot the Linux server after you have installed all the packages.
Installing ISC Server Instrumentation
1. InserttheSoftwareKitCDintotheLinuxserverCDROMreader.
2. Mount the CD using either of the following methods:
• Enter the mount command as follows:
mount /mnt/cdrom
• Use the Disk Management utility. To invoke this utility click the Start button, select
System, and then select the Disk Management menu option.
3. List the contents of the Software Kit CD and make sure the ISC install packages and scripts are
on the CD. You can locate these packages in the /Software/Linux directory. Use the following
commands to move to that directory and list the files:
cd /mnt/cdrom/Software/Linux
ls