NVM Information Guide—ICH8
6
Figure 1. LAN NVM Regions
To access the NVM, it is essential to correctly setup the following:
1. A valid Flash Descriptor Region must be present. Details for the Flash Descriptor
Region are contained in the ICH8 EDS. The
FTOOL.exe utility provides the easiest
method of configuring this descriptor region. This process is described in detail in
the Intel
®
Active Management Technology OEM Bring-Up Guide.
FTOOL.exe and the Intel
®
Active Management Technology OEM Bring-Up Guide
can be obtained as part of the Intel Active Client Manager kit on ARMS
(https://platformsw.intel.com/) or by contacting your local Intel representative.
2. The GbE region must be part of the original image flashed onto the part.
3. For Intel LAN tools and drivers to work correctly, the BIOS must set the VSCC
register(s) correctly. This information is described in ICH8 EDS, section 24.1.
4. The GbE region of the NVM must be accessible. To keep this region accessible, the
Protected Range register of the GbE LAN Memory Mapped Configuration registers
must be set to their default value of 0000 0000h. (The GbE Protected Range
registers are described in the ICH8 EDS).
5. If you are using the 82566, the ICH8 soft strap for the GLCI interface must be set
correctly. Bit 19 of STRP0 must be set to 1b (as described in the ICH8 EDS). For the
82562V, this bit can be set to 0b, since it does not use the GLCI bus.
Flash Descriptor
Region
0
GbE
Region
3
BIOS
Region
1
ME
Region
2