Filter
Top Products
- 31 -
Intel 945 Series User's Manual
・
Video off Method
・
Video Off In Suspend
This determines the manner in which the monitor is blanked. The choices are Yes Video
will off and No Video always on.
・
Suspend Type
This item allows you to select ACPI Suspend Type.
・
MODEM Use IRQ
This determines the IRQ in which the MODEM can use. Default option is IRQ3.
・
Suspend Mode
If system activity is not detected for the length of time specied in this eld, all devices
except CPU will be shut off. Select [Disabled] can not suspend.
・
HDD Power Down
If HDD activity is not detected for the length of time specied in this eld, the HDD will
be shut off.
・
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-
Off state.
・
CPU THRM-Throttling
This option allows you to adjust the CPU temperature. If the CPU temperature gets to the
temperature you set, CPU frequency will be throttling. The range is 12.5% to 87.5%,
increase by 12.5%.
・
Wake-Up by PCI card
When set to [Enabled], the feature allows your system to be awakened from the Power
saving modes through any event on PCI device.
・
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During
Enabled, the system will boot up if there's an incoming call from modem.
・
Resume by Alarm
The eld is used to enable or disable the feature of booting up the system on a scheduled
time/date.
・
Date (of Month) Alarm
[0]: This option power-on the system everyday according to the time set in the “Time
(hh:mm:ss) Alarm” item.
[1-31]: This option selects a date you would like the system to power-on. The system
will power-on on the date set, and the time set in the “Time (hh:mm:ss) Alarm” item.
・
Time (hh:mm:ss) Alarm
This item sets the time you would like the system to power-on.
・
Primary/ Secondary IDE 0/1
When the Primary/Secondary IDE 0/1 devices are activity, whether cancel PC and IDE
saving mode.
・
FDD, COM, LPT Port
When the FDD, COM, LPT Port are activity, whether cancel the PC and IDE saving mode.
・
PCI PIRQ[A-D]#
This option is for setting PCI PIRQ.
V/HSYNC+Blank
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Support Initial display power management signaling.( default)