Filter
Top Products
- 23 -
Intel 945 Series User's Manual
・
Security Option
This item determines when the system will prompt for password - every time the system
boots or only when enters the BIOS setup.
[Setup]: The password is required only when accessing the BIOS Setup.
[System]: The password is required each time the computer boots up.
Note:
Don’t forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
・
APIC MODE
This eld is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2004 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
・
MPS Version Control For OS
This item species which version of MPS (Multi-Processor Specication) this mainboard
will use. Leave this item at its default setting.
・
Singal CPU Work Mode
Change the Dual-Core CPU to the single core mode. This item will be enabled while using
Dual-Core CPU.
・
OS Select For DRAM > 64MB
Allow OS2 to be used with >64MB or DRAM. Settings are Non-OS/2 (default) and OS2.
Set to OS/2 if using more than 64MB and running OS/2.
・
Report No FDD For WIN 95
When set to [Yes], this item allows you to run some older operating system without
oppy disk drive. Leave this item to its default setting.
・
Full Screen LOGO Show
This item determines to show the full screen logo when booting.
・
Small Logo(EPA) Show
EPA Logo is the sign at the top of the screen when POST. If you don't want to show this
logo, please set "Disabled".