Filter
Top Products
- 26 -
Intel 945 Series User's Manual
►
OnChip IDE Device
Click <Enter> key to enter its submenu:
IDE HDD Block Mode
Enable this eld if your IDE hard drive supports block mode. Block mode enables BIOS to
automatically detect the optimal number of block read and writes per sector that the
drive can support. It also improves the speed of access to IDE devices.
IDE DMA transfer access
This item allows you to enable the transfer access of the IDE DMA then burst onto the
PCI bus and nonburstable transactions do not.
On-Chip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select [Enabled] to activate each channel separately.
IDE Primary Master/Slave PIO
Each IDE channel supports a master device and a slave device. These four items let you
assign the kind of PIO (Programmed Input/Output) were used by the IDE devices.
Choose Auto to let the system auto detect which PIO mode is best, or select a PIO mode
from 0-4.
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
IDE HDD Block Mode
IDE DMA transfer access
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
Item Help
Menu Level
►►
If your IDE hard drive
supports block mode
select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support
*** On-Chip Serial ATA Setting***
On-Chip Serial ATA
x SATA PORT Speed Settings
x PATA IDE Mode
SATA Port
[Auto]
Disabled
Primary
P1,P3 is Secondary
↑↓
→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Enabled
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
►
OnChip IDE Device
►
Onboard Device
►
SuperIO Device
x KB Power ON Password
x Hot Key Power ON
[Press Enter]
[Press Enter]
[Press Enter]
Enter
Ctrl-F1
Item Help
Menu Level
►
↑↓
→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Press Enter
4.5.6 Integrated Peripherals