Filter
Top Products
2 Setting Up the Chassis
Intel® Entry Server Chassis SC5275-E User Guide 9
2 Setting Up the Chassis
This chapter describes how to set the server up for the first time. With the exception of replacing
the front panel board (discussed in Chapter 4), it is necessary to remove only the left access cover,
not the cover at the right.
Tools and Supplies Needed
Phillips (cross head) screwdriver (#2 bit)
Small flathead screwdriver
Antistatic wrist strap (recommended)
Installation Safety Instructions
Only technically qualified personnel should integrate this assembly.
Follow these guidelines to meet and maintain safety and product regulatory requirements when
integrating this chassis subassembly.
Read and adhere to all of these instructions and the instructions supplied with this assembly. If you
do not follow these instructions, the UL listing will be void, and the product will most likely be
non-compliant with other regional product laws and regulations.
Safety: Before You Remove the Access Covers
Before removing the access cover for any reason, observe these safety guidelines:
Turn off all peripheral devices connected to the server.
Turn off the server by pressing the power button on the front of the chassis. Then unplug the
AC power cord from the chassis or wall outlet.
Label and disconnect all peripheral cables and all telecommunication lines connected to I/O
connectors or ports on the back of the chassis.
Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap
attached to chassis ground—any unpainted metal surface—when handling components.