Filter
Top Products
Hardware Installation- 27 -
English
8) IDE1/IDE2/IDE3 (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect
to one IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or
optical drive). If you wish to connect two IDE devices, please set the jumper on one IDE device
as Master and the other as Slave (for information on settings, please refer to the instructions
located on the IDE device).
To ensure that an IDE CD-ROM drive can work properly, please attach it to the IDE 1/IDE 2
connector.
7) FDD (Floppy Connector)
The FDD connector is used to connect the FDD cable while the other end of the cable connects to the
FDD drive. The types of FDD drives supported are: 360KB, 720KB, 1.2MB, 1.44MB and 2.88MB.
Please connect the red power connector wire to the pin1 position.
1
2
33
34
12
3940
Only for GA-8N-SLI Royal.