Intel GS-SR195V Server User Manual


 
15
Hardware Installation Process
Step 2-5: PCI Expansion Card Installation
GS-SR195V provides expansion riser slot for one PCI-X 64/66MHz slot; and one with PCI-E
x8 and x4 slots. To install the peripheral, please go through the following steps.
Note:
Before installing the PCI expansion card, please check the card size limitation. Size limitation for
PCI-E is listed below:
Heigth: 18.73mm(max) ; Length: 167.65mm(max) ; Width: 52mm(max)
Step 1 Lift the riser bracket slightly, then pull it out from the server chassis.
Step 2 Align the expansion card with the guiding groove. Slide the expansion card into the slot until
the card firmly seats.
Step 3 Align the riser bracket to the system module (see the arrow direction mark 1), and push
it to locked position.
Note!! The riser bracket must be firmtly seated into the module. (See the arrowdirection),
or it will cause power connection losses.
Step 4 Reverse Step 1 & 2 to lock the riser bracket firmly. Installation completed.
Step 1
Step 2
Step 3