43
BIOS Setup
Serial ATA
Enabled Enable Serial ATA device. (Default value)
Disabled Disable the Serial ATA.
Native Mode Operation
This option allows user to set the native mode for ATA function.
Note that certain OS is not supported under Native Mode.
Auto Auto detected. (Default value)
Serial ATA Set Native mode to Serial ATA.
Parallel ATA Set Native mode to Parallel ATA.
Reset Configuration Data
Yes Clear the Extended System Configuration Data (ESCD) area.
No Disable this function. (default value)
Clk Gen Spread Spectrum
Enabled Enable ClkGen Spread Spectrum.
Disabled Disabled this function. (Default value)
System After AC Back
Set the mode od operation if an AC/Power loss occurs.
Power On Power on system without pressing power button.
Stay Off Keep the power off until the power button is pressed.
Pre- State Set system to the last sate when AC power is removed. Do not power on
system when AC power is back. (Default value)