Filter
Top Products
INSTALLATIONS
IB865 User’s Manual 7
ATX Power Installation
The system power is provided to the CPU card with the CN1 and J7 ATX
power connectors. Please note that the J7 external ATX power connector
should be connected to the backplane for IB865 to function. J7 is a 3-pin
power connector. CN1 is a 4-pin 12V power connector. CN1 is to be
connected to the ATX power supply.
Installing the Memory
The IB865 CPU card supports two DDR memory sockets for a maximum
total memory of 2GB in DDR memory type. You can install unbuffered
& non-ECC DDR DIMMs. It supports DDR266/333 when installed with
CPUs that have clock speeds of 533MHz. It supports DDR266/320/400
when installed with CPUs that have clock speeds of 800MHz. The board
provides dual channel functionality for its DIMM slots. DIMM1 is for
one channel and DIMM2 is for the other channel. Enabling dual
channels can increase data access rates.
Basically, the system memory interface has the following features:
Supports two 64-bit wide DDR data channels
Available bandwidth up to 3.2GB/s (DDR400) for single-channel
mode and 6.4GB/s (DDR400) in dual-channel mode.
Supports non ECC DIMMs.
Supports 128Mb, 256Mb, 512Mb DDR technologies.
Supports only x8, x16, DDR devices with four banks
Registered DIMMs not supported
Supports opportunistic refresh
Up to 16 simultaneously open pages (four per row, four rows
maximum)