Filter
Top Products
BIOS SETUP
48
MB884 User’s Manual
Video Off In Suspend
When enabled, the video is off in suspend mode.
Suspend Type
The default setting for the Suspend Type field is Stop Grant.
Modem Use IRQ
This field sets the IRQ used by the Modem. By default, the setting is 3.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices except
the CPU will be shut off.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk drive
will be powered down while all other devices remain active.
Soft-Off by PWRBTN
This field defines the power-off mode when using an ATX power supply. The Instant
Off mode allows powering off immediately upon pressing the power button. In the
Delay 4 Sec mode, the system powers off when the power button is pressed for more
than four seconds or enters the suspend mode when pressed for less than 4 seconds.
Wake-Up by PCI Cards
Enable this field to allow wake up function through a PCI Ethernet card.
Power On by Ring
This field enables or disables the power on of the system through the modem
connected to the serial port or LAN.
Wake Up On LAN
Enable this field to allow wake up function through the onboard LAN.
Resume by Alarm
This field enables or disables the resumption of the system operation. When
enabled, the user is allowed to set the Date and Time.
Reload Global Timer Events
The HDD, FDD, COM, LPT Ports, and PCI PIRQ are I/O events which can prevent
the system from entering a power saving mode or can awaken the system from such a
mode. When an I/O device wants to gain the attention of the operating system, it
signals this by causing an IRQ to occur. When the operating system is ready to
respond to the request, it interrupts itself and performs the service.