Intel MP3000 Computer Hardware User Manual


 
MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
97
The PTZ camera will run AutoPan based on your preset position
settings. For example, if
is chosen and the Dwell/Speed
of preset position 1 and 2 are 3 seconds/30 per second and 6
seconds/90 per second.
Therefore, once you click the
AutoPan button, the camera
first turns at a speed of 30/sec from its current position to position
1 and stays for 3 seconds, then from position 1 to 2 at a speed of
90 /sec and stays for 6 seconds. The camera continues to go
around in such a fashion (2Æ3, 3Æ4, 4Æ1, 1Æ2, …..)
PTZ cameras of different makes can have different ways to
run the AutoPan function and might differ from the above.
Refer to the respective user’s manual of the PTZ camera.
2. Exit PTZ Controller
Simply click
to exit from PTZ controller interface.
MicroJack User’s Manual
EYES Pro/MP2016/MP3000/MP5000
98
Status Monitoring
Alarm / Relay /Sensor Status
On the right side of the main surveillance
window is a panel that shows alarm, relay and
sensor status. Installed sensors are shown in
bright color while not installed ones remain
dark. Once a sensor is activated, the color will
turn yellow. For relays, installed ones are
shown in bright color and activated ones turn
yellow color.
When an alarm is triggered, the
will turn
red color. Double-clicking on this button will bring up the following
dialog box.