Filter
Top Products
15 Chapter 2 Installation
point down into the SODIMM socket.
3. Slip the SODIMM into the socket at a 45 degree angle and care-
fully fit the bottom of the card against the connectors.
4. Gently push the SODIMM into a perpendicular position until the
clips on the ends of the SODIMM sockets snap into place.
5. Check to ensure that the SODIMM is correctly seated and all con-
nector contacts touch. The SODIMM should not move around in its
socket.
2.11 ATX power control connector (CN5)
The PCI-6886 support ATX power. CN5 supplies main power (+5V,
+12V, 5VSB), and it is a 6 x 2 power connector, w/Fixed Lock, type:
4200-WS-A1.
Notice The PCI-6886 can support ATX feature func-
tion. When the PCI-6886 is used as a stand
alone card, the 12-pin main power connector
(CN5) must be connected to the power supply.
If the PCI-6886 is used with a passive back-
plane, the main power connector (CN5) should
not be connected as the card will be powered
from the backplane. But when the ATX feature
function is needed, the ATX feature cable (p/n:
1700001276) should be connected with ATX
feature connector on backplane, one side of
1700001276 is 12pin header, it should be con-
nected with CN5; the other side is 3-pin
header, it should be connected with the ATX
feature connector on backplane.
Important Make sure that the ATX power supply can take
at least a 10 mA load on the 5 V standby lead
(5VSB). If not, you may have difficulty power-
ing on your system.