Filter
Top Products
troubLesHootinG
When you initially plug in and turn on the power to a PowerLine adapter,
the Power LED should light. After approximately 10 seconds, the
PowerLine LED should also light, and the Ethernet LED should blink.
If the Power LED fails to light:
• If the AC power outlet is controlled by a wall switch, make sure the
switch is in the On position.
• Verify that the wall socket is live. To do this, disconnect the PowerLine
adapter and plug in another electrical product. If the Power LED still
doesn’t light and you’ve conrmed the power outlet is live, you have a
hardware problem and should contact technical support.
If the PowerLine LED fails to light (but the Power LED is lit):
• Make sure that power is being provided to more than one PowerLine
device. Another PowerLine device must be installed for successful
communication across the PowerLine.
• Verify that the network password is the same on all devices.
If the Ethernet LED fails to light and blink:
• Make sure that the Ethernet cable is plugged in properly at both ends.
• Be sure you’re using the correct cable on the router the rst PowerLine
adapter is connected to. When connecting the router’s Internet port to
a cable or DSL modem, use the cable (straight-through or crossover)
supplied with the modem.
• On the attached Ethernet device or network adapter card, check that
the Link LED is lit.
9