Filter
Top Products
44
45
5. Make sure both units are connected by the Cat 5 cable, then plug in the Remote unit’s power
adapter.
6. Press and hold the Local unit’s Selection button, then plug in the Local unit’s power adapter.
7. Wait until both green front panel LEDs on the Local unit are ashing on and off, then release the
Selection button.
8. Make sure the orange LED on the front panel of the Remote unit is on (indicating that Firmware
Upgrade Mode is in effect.
Note:
If the LED is not on, or it is blinking, the unit is not ready to be upgraded. You must repeat steps 6
and 7.
Starting the Upgrade
To upgrade your rmware:
1. Run the downloaded Firmware Upgrade Package le - either by double clicking the le icon, or by
opening a command line and entering the full path to it.