Juniper Networks 500 Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 11 of 42
02867 – If the DHCP relay server is set with an IP address, the device
incorrectly attempted to resolve the IP address with the host name even
though there was no hostname.
02861 – IP swapping issues occurred on the Juniper NetScreen-5000 Series
systems sometimes because of invalid cache.
02845 – In an NSRP active-passive configuration, improper MAC table
entries prevented the backup device from being managed.In some instances,
you could not manage a backup device in an NSRP active-passive
configuration.
02810 – A policy with the negate option did not free memory on the device
properly, creating a memory leak, degrading performance on the device.
02798 – The Juniper NetScreen-5000 Series systems sometimes had a
redundant buffer when receiving out-of-order fragmented VPN packets.
02787/03020 – A memory leak caused by a failed DNS query on a Juniper
NetScreen-5200 in an HA pair caused the primary system to fail.
02774 – Multiple trace routes occurred after you created a BGP neighbor to a
device in an HA pair, disabled HA synchronization, and then attempted to
redistribute routes from the primary device to the backup device.
02768 – When the primary device attempted to synchronize with the backup
device and sent it a new DIP session, the backup device could still have the
existing DIP session and could not perform the synchronization.
02762 – If you attempted to display 100 logs per page in the WebUI Traffic
Log, the WebUI displayed no logs.
02725 – In an NSRP device pair, the primary device generated a log that
indicated that multiple failovers occurred, but the backup device only
generated one log, indicating only one failover.
02710 – The Unknown Protocol SCREEN option did not work on the Juniper
NetScreen-5000 Series systems.
02656 – The WebUI home page did not display the status for Layer 2
interfaces.
02620 – Issuing the debug command for the WebSense server, caused the
device to fail.
02604 – When a device exported routes from a Vsys to a root virtual router,
the exported routes were not tagged with the correct Vsys ID.
02602 – Attempts to establish Telnet, WebUI, and SSH, sessions to the
interface, where management was enabled, failed, when a route from the
correct interface was not provided or the route pointed to a different
gateway.