Juniper Networks 500 Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 16 of 42
02822 – The DHCP utility did not work on one of the redundant interfaces
on a device. The interface did not appear in the DHCP environment in the
WebUI.
02814 – The SNMP interface index values were inconsistent through the
SNMP tree. Interface index values uniquely identify each interface.
02805 – Under certain traffic conditions, some DNS and HTTP session
timers were set with higher values than the DNS and HTTP service
timeouts.
02796 – When the device sent out a trap that indicated an SNMP
authentication failure when OSPF was enabled, the device failed.
02788 –In certain situations, an Juniper NetScreen-5000 device failed when
it received a high number of bad IKE packets.
02786 – If the packet that had both a destination broadcast subnet IP
address and a MAC multicast address attempted to enter the device, the
device dropped it.
02785 – A Juniper Networks security appliance failed continuously because
an interface on the device did not check that the PPP (Point-to-Point
Protocol) encapsulation functioned properly.
02771 – Traffic through a MIP (Mapped IP) address with both source-based
routing and traffic shaping enabled failed.
02765 – If a configuration is pushed to the device by Security Manager and
the heartbeats to the device are lost, the device would invoke the
configuration rollback feature because the heartbeat missed threshold was
too short.
02740 – The Security Manager Log Viewer did not display data in the Alert
column. The Alert column now correctly displays traffic logs associated with
policies that have the Alert setting selected.
02736 – The Mgt-IP on a VSI replied with a virtual MAC address instead of
a physical MAC address for the Ident-reset.
02734 – When you performed an SNMP walk operation on the Policy MIB,
the procedure incorrectly displayed an integer to represent the custom
service. It now correctly displays a string to represent a custom service in the
Policy MIB.
02730 – For external LSAs (Link State Advertisements) that have a
forwarding address, the priority for a forwarding route incorrectly used the
interface cost as the priority value rather than the metric of intra- and inter-
area OSPF routes. The metric is the correct value to use for setting a route
priority.
02718 – Importing a device into Security Manager failed because the
heartbeat timeout was exceeded and was not user configurable.