Juniper Networks T1600 Network Router User Manual


 
Configuration of SONET or SDH framing on a per-port basis on the 4-port Type 4 PIC
SONET/SDH framing
Link aggregation
Alarm and event counting and detection
Dual-router automatic protection switching (APS)
Multiprotocol Label Switching (MPLS) fast reroute
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
Duplex LC connector (Rx and Tx)
Optical interface supportSee Table 43 on page 104
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the request chassis pic offline command in the
JUNOS System Basics and Services Command Reference.
Cables and connectors
One tricolor LED per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
One 768 over 192 LED:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
SONET/SDH OC192c/STM64 PICs with XFP 103
SONET/SDH OC192c/STM64 PICs with XFP