Filter
Top Products
21
Getting Started Preparation Basic Operation Settings Troubleshooting Others
ENGLISH
b Adjust the focus
c Adjust the image size (zoom)
d To end
F Turn off the power
zSwitches between “Focus” and “Zoom” whenever the [ENTER] button is
pressed.
zThe power cannot be turned off within approximately 90 seconds after it
has been turned on. Start operation only after 90 seconds time.
zYou can also press the [STANDBY/ON] button on the unit to turn off the
power. (pP11)
zPut back the lens cap after use to prevent the lens from dirt.
zPull out the power plug when the unit will not be used for a prolonged time.
ENTER
Adjust accordingly by
pressing the up down buttons
Press for 1 second
or more
Focus
ENTER
ENTER
Adjust accordingly by
pressing the up down buttons
Zoom
EXIT
You can hide the image
...............................
temporarily
You can hide the image temporarily.
zPress the [HIDE] button again to
display image.
zThe power cannot be turned off
when the image is temporarily
hidden.
...............................
About Cool Down mode
z
The Cool Down mode is a function
to cool down the lamp for
approximately 60 seconds after
projection is complete.
This function prevents the internal
parts of the unit from deformation
or damage due to overheating of
the lamp. It also prevents lamp
blowout and premature shortening
of lamp life.
zDuring Cool Down mode, the
[STANDBY/ON] indicator blinks in
red.
zAfter the Cool Down mode is
complete, the unit automatically
returns to standby mode.
zDo not pull out the power plug
during Cool Down mode. This may
shorten the lamp life and cause a
malfunction.
TIPS
MEMO
HIDE
A STANDBY/ON
Green light blinks when
the image is hidden
A STANDBY/ON
A STANDBY/ON
OFF
OFF
While a confirmation screen is displayed
Cool Down mode
Light on (Red)
Blinking (Red)
DLA-RS2_EN.book Page 21 Friday, October 12, 2007 2:43 PM