Filter
Top Products
62 EN
HARDWARE
Power-saving mode
In compliance with the operation regulations of the International Energy Star Program, this unit
enters the power-saving mode when no operation is performed for a certain period.
On the [Power Schemes] tab in the “Power Option Properties” screen (page 61), you can specify
the time that must expire before the unit enters the power-saving mode. The table below shows
the factory settings.
Operating on
AC power
Status
1 Turn off monitor: 15 minutes 5 minutes
2 Turn off hard disks: 30 minutes 5 minutes
3 System standby: 20 minutes 5 minutes
4 System hibernates: 3 hours 2 hours
The LCD screen turns off.
The
(Stand By) lamp is still lit in green.
The hard disk power is turned off with
the LCD screen kept off. The
(Stand By) lamp is still lit in green.
The PC stores the current system status
on the hard disk. The
(Stand By) lamp
will go out.
The LCD screen is turned off.
The (Stand By) lamp flashes in green.
Tips
To exit status 1 or 2 , move the stick or press any key on the keyboard.
To exit status 3 , press the Power key or any key on the keyboard.
To exit status 4 , press the Power key.
Important
• In statuses 1 through 3, Windows is still running. Note that the current condition is
lost if the PC is turned off by pressing the Power key for more than 4 seconds.
Operating
on battery
XP7210/3210EN-48-65 02.8.6, 7:57 PM62