Filter
Top Products
Before Use
78
|
English
Disc source
?
The disc control mode cannot be selected.
✔ No wire has been connected to the disc
changer input terminal on the unit.
Connect the wire to the disc changer input
terminal on the unit.
?
The specified disc does not play, but another
one plays instead.
✔ The specified CD is quite dirty.
Clean the CD.
✔ The CD is upside-down.
Load the CD with the labeled side up.
✔ The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the number
for the specified disc.
✔ The disc is severely scratched.
Try another disc instead.
?
The sound skips.
✔ Something is touching the disc changer.
Remove whatever is touching it.
✔ The CD is scratched or dirty.
If skipping happens at the same place when
the car is stopped, something with the CD is
wrong. Clean the CD.
?
The display shows that the changer is being
played, but no sound can be heard.
✔ The computer chip in the unit is not
functioning normally.
Press the reset button on the unit (page 4).
?
The specified track will not play.
✔ Random play or magazine random play has
been selected.
Turn off random play or magazine random
play.
?
Track repeat, disc repeat, track scan, disc scan,
random play, and magazine random play start
by themselves.
✔ The setting is not cancelled.
The settings for these functions remain on until
the setting to off or the disc ejected, even if
the power is turned off or the source changed.
?
Can not remove disc.
✔ The cause is that more than 10 minutes has
elapsed since the vehicle ACC switch was
turned OFF.
The disc can only be removed within 10
minutes of the ACC switch being turned OFF.
If more than 10 minutes has elapsed, turn
the ACC switch ON again and press the Eject
button.
MP3/WMA source
?
Cannot play an MP3/WMA.
✔ The media is scratched or dirty.
Clean the media, referring to the Disc cleaning
of the section on <About discs> (page 13).
?
The sound skips when an MP3/WMA is being
played.
✔ The media is scratched or dirty.
Clean the media, referring to the Disc cleaning
of the section on <About discs> (page 13).
✔ The recording condition is bad.
Record the media again or use another media.
?
The MP3/WMA track time is not displayed
correctly.
✔ ---
There are times when it isn’t displayed correctly
according to the MP3/WMA recording
conditions.
?
Can not display the ID3 tag information
correctly.
✔ Record is not made in conformity with the ID3
tag version 1.x.
Record in conformity with the ID3 tag version
1.x.
Also, the display may be incorrect if an
MP3/WMA file uses the ID3 tag v1.x standard
and if this standard has been expanded after
production of the machine software.