Filter
Top Products
Connecting Component Video Equipment withYCbCr output jacks to the
RGB IN connector
You can also connect the video
component to the RGB IN connector, if
the video component has the component
video (YCbCr) signal jacks. This
connection may provide a better picture
quality than the connections on page 8.
• You can switch the input source to
VIDEO, S-VIDEO, or RGB.
• The AUDIO IN jack is for equipment
connected to the RGB IN connector.
Before connecting
• Turn off the components that are to be
connected.
• The projector and computer will be
turned on in "Using the Projector".
Do not turn on either the computer or
unit until you read this section.
• Please also refer to the manual of the
video component to be connected.
If you are connecting a 5 wire BNC cable
to a 15 pin D-sub, you may need three
21-131-0 BNC to RCA adaptors.
Connect the 15 pin D-sub into the
projector. Connect the red BNC to the Cr
output. Connect the green BNC to the Y
output. Connect the blue BNC to the Cb
output.
The remaining black and gray BNC
connectors are not used in this case.
When initially displaying component
video the color may require adjustment.
To adjust the color, using the remote to
the “Image Adjust Menu” and adjust
the “Hue” Cr and Cb (red and blue) as
required.
.
9