Kodak 5600 Projector User Manual


 
Replacements and Installations
SM5440-1 – 18NOV97 5
[4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[5] Pull the SMALL CIRCUIT BOARD up.
[6] Remove the
Torx
SCREW from the BLOWER COVER ASSEMBLY.
[7] Lift the GRILLE ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.
[8] Loosen the
Torx
SCREW on the right track of the LOWER LIGHT BAFFLE ASSEMBLY appoximately half way.
[9] Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER ASSEMBLY.
[10] Remove the 2 long
Torx
SCREWS from the BLOWER COVER ASSEMBLY.
[11] Lift the BLOWER COVER ASSEMBLY up.
[12] Remove the 3
Hex
1/4 in. SCREWS from the MOTOR.
[13] Lift the MOTOR until you observe the FAN BELT and MECHANISM BELT.
[14] Remove the FAN BELT and MECHANISM BELT off the MOTOR PULLEY. Use SPRING HOOK TL-1165.
Caution
Move the MOTOR to allow access to the parts; wires are still connected to the MOTOR. Do not cause damage to
the MOTOR wires.
[15] Remove the RETAINER CLIP from the FAN SHAFT.
[16] Pull the FAN up and off the FAN SHAFT to allow access to the FAN BELT.
[17] Remove the FAN BELT.
[18] Remove the 3
Torx
SCREWS from the FAN SHAFT ASSEMBLY.
A100_0031HA
A100_0031HCA
KK models
GRILLE ASSEMBLY
BLOWER COVER WIRE TIE
WIRE TIE (not shown)