Filter
Top Products
Contents
12
A TV-tuner is optional for the
KODAK DP1050 ULTRA
NOTE! Requires TV tuner to be installed.
In order to use the KODAK DP1050 ULTRA as a TV
output; connect the TV antenna to the TV connector on
the KODAK DP1050 ULTRA plug panel.
The KODAK DP1050 ULTRA behaves just like a
normal TV. See the menus section 7.2.6 on how to
adjust the TV settings.
There are basically three ways of receiving the TV
signals to the KODAK DP1050 ULTRA:
◆ Antenna (Terrestrial)
◆ Cable
◆ Set-up box for satellite
These three work differently and it is important to
consider the options of each when adjusting the
KODAK DP1050 ULTRA settings.
Antenna
When you adjust your TV to signals from an antenna
you must store each channel in a different program. .
The same is true for the KODAK DP1050 ULTRA TV-
tuner. When connected to an antenna you assign the
different channels to the programs in the Television
Setup Menu. Then you use the Up and Down arrows
in the menu, remote control or the channel up/down
button on the control panel to switch between channels.
5. Connecting a TV- source to the
KODAK DP1050 ULTRA
Figure 11: Connecting to TV- source
1332 (ELEK). KODAK ENG 15.07.98 13:33 Side 12