Filter
Top Products
20
Simultaneous Projection
1. With the KODAK EKTAPRO Twin
Socket Adapter (accessory)
You can connect two projectors in parallel
using the Twin Socket Adapter and an
EKTAPRO Twin Socket Connecting cable
(accessory). The adapter is inserted into
the remote control socket (4). The cable
connects the Twin Socket Adapter with the
remote control socket of the second projec-
tor (see illustration).
You control the projectors with the cable
remote control as shown in the drawing.
The connection of the IR receiver is also
possible. However, this can only be con-
nected to the receiver with the 8 m extension
cable (accessory).
2. Using the KODAK EKTAPRO IR Re-
mote Systems
Several EKTAPRO Projectors can be op-
erated simultaneously when each projector
is equipped with an EKTAPRO IR Receiver
(available as accessory, see page 22).
This mode should only be used for slide
change purposes! The focus operation
will occur on all projectors in parallel!
Ensure that all receivers and the
transmitter are set to the same channel!
Random access operation
Any slide can be selected using the
KODAK EKTAPRO IR Remote System
(available as accessory, see page 22). Ac-
cess is fast, within approx. 5 sec: Input the
required slide number to your IR remote
control and confirm using <*>.
The RA operation is ideal for lectures, inter-
active learning programmes and computer
control. For further details, please see the
instructions manual for the IR EKTAPRO
Remote System RA and EKTAPRO IR Re-
mote System RA/LP.
WARNING:
Always switch off the projector and
unplug the mains lead before
replacing a fuse!
Avoid the risk of fire, replace only
with a fuse of same type and rating!
Replacement of primary circuit fuse
1. Pull out the fuse link compartment
(11). Do not change the position of the fuse
holder when reinserting into the projector
(see also page 16).
. Replace the defective fuse (14) (tech-
nical data, page 23).
. Push the fuse link compartment back
into the projector.
1.
Replacement of fuses
Service
Note:
Simultaneous Projection with other
EKTAPRO models
If transport buttons are held down longer
than a second the trays may stop at differ-
ent positions due to different slide change
times
Operation via timer
It is not allowed to operate the KODAK
EKTAPRO 320 Slide Projector with an
external timer!