Filter
Top Products
A-61182 October 2001 9
Output tray
1. Lift the output tray to about a 30° angle.
2. Insert the three protrusions on the output tray into the three slots on the ADF.
3. Release the output tray.
4. Make sure that the output tray is firmly attached to the ADF.
5. Pull the output tray extension wire out to the desired length.
Powering up the scanner
Make sure that you press the I/O power switch and not the SCSI terminator switch
(which has an ON/OFF label under it) when you want to turn the scanner on or off.
The scanner must be on and its self-test completed before you power up the PC.
IMPORTANT: Before you power up the scanner, make sure that there are no
documents in the ADF or on the flatbed platen.
Turning on the scanner
• Press the side of the power switch that is marked “I” to turn on the scanner.
The power light on the ADF illuminates. If it does not, check the power source.
Turning off the scanner
• Press the side of the power switch that is marked “O” to turn off the scanner.
Output tray
extension wire
Protrusion
Output tray
POWER LED (green)
READY LED (green)
ERROR LED (red)