Filter
Top Products
5
5.5 Specifying Copy Settings
5-18 Di1610/Di1610p
Using the Utility Mode Chapter 5
5.5 Specifying Copy Settings
When the machine is turned on or the [Panel Reset] key is pressed, the machine is
automatically reset to its initial mode. By changing the default settings, you can
change the initial mode. Refer to the following table for the default settings for each
function.
No. Name Description
1 PAPER PRIORITY The tray that is given priority can be set to either “Tray1” or “Tray2”.
• The factory default setting is “TRAY1”.
2 DENSITY PRIORITY The density that is selected when the machine is turned on or the [Panel
Reset] key is pressed can be set to “AUTO”, “MANUAL” or “PHOTO”.
• The factory default setting is “AUTO”.
3 DENSITY LEVEL (A)
*(A) : Auto
The default Auto density level setting can be set to “LIGHT (–1)”,
“NORMAL (0)” or “DARK (+1)”.
• The factory default setting is “NORMAL (0)”.
4 DENSITY LEVEL (M)
*(M) : Manual
The default manual density level setting can be set to one of nine levels
between –4 and +4, with the normal print density at 0.
If a smaller number (toward –) is selected, the print becomes lighter. If
a larger number (toward +) is selected, the print becomes darker.
• The factory default setting is “NORMAL (0)”.
5 OUTPUT PRIORITY The finishing setting that is selected when the machine is turned on or
the [Panel Reset] key is pressed can be set to “NON” or “SORT”.
• The factory default setting is “NON”.
6 RESOLUTION The default resolution when scanning with the Auto Document Feeder
can be set to “600 dpi
× 300 dpi” or “600 dpi × 600 dpi”.
• The factory default setting is “600 dpi
× 300 dpi”.