Filter
Top Products
40
Clip parameter list
Playback Type and Playback Pattern selection
In Clip Edit mode you can choose a playback type and pattern; set the Start, End, Loop and
Index Points; and specify the BPM value. The Start Point will always be the location from
which playback begins, and the End Point will always be where playback either ends, or
returns to the Loop point. In Type 1 and Type 2, the Start Point is used as the Loop Point; In
Types 3 and 4 you are free to set an independent Loop Point. The Index point is used to select
the single frame that will represent the clip when displayed in Bank mode.
When you hold down the EDIT key and press the clip key for the clip you want to edit, the
first thing to appear in the VALUE display will be “T.#. - #.”. The first value (T.1.–T.4) speci-
fies how the playback type, and the second value (-#) specifies the playback pattern.
NOTE Once you’ve specified the playback type, you won’t be able to change this setting unless you
exit Clip Edit mode, and begin editing again.
NOTE If you press the Play key while performing clip editing, playback will occur between the Start
Point and End Point you specified. You are free to specify an Index Point that is outside the
range of the Start/End Points.
Type 1: Specified End Point
Patterns of this type will play or loop between the Start Point and End Point. This is the most
basic type of pattern.
Start Point
Start Point
End Point
End Point
Index Point
Index Point
Sampling Data
Pattern 1: Normal Loop
Start Point End Point
Sampling Data
This pattern plays from the Start Point to the End Point,
then returns to the Start Point and continues to play
repeatedly.
Pattern 2: Alternating Loop
Start Point End Point
Sampling Data
This pattern plays from the Start Point to the End Point,
then plays backward toward the Start Point, and contin-
ues repeating this action.