Filter
Top Products
35
TECHNICAL SPECIFICATIONS - CHASSIS 400 / 620 SC ‘99
400 SC 620 SC
Frame Central chrome-moly-steel frame
Fork White Power – Up Side Down 43
Wheel travel front/rear 295 / 320 mm (11,6 / 12,6 in)
Rear suspension Central shock absorber (WP) with PRO-LEVER linkage to rear-swingarm with needle bearing
Front brake Disc brake with carbon-steel brake disc Ø 260 mm (10,2 in), brake caliper floated
Rear brake Disc brake with carbon-steel brake disc Ø 220 mm (8,7 in), brake caliper floated
Tyres front 90/90-21 54R
Air pressure offroad 1,0 bar (14 psi)
Air press. road, driver only
1,5 bar (21 psi)
Tyres rear 140/80-18 70R
Air pressure offroad 1,2 bar (17 psi)
Air press. road, driver only
2,0 bar (28 psi)
Fuel tank capacity 9 liter (2,38 US gallons) of that 2,5 liter (0,66 US gallons) reserve
Final drive ratio 16:48 (14:50) 16:40 (15:50)
Chain 5/8 x 1/4 " O-Ring
Steering angle 62,5°
Wheel base 1510 ± 10 mm (59,4 ± 0,4 in)
Seat high 940 mm (37 in)
Ground clearance 375 mm (14,8 in)
Dead weight without fuel
122 kg (269 lbs)
NOTE FOR WHITE POWER FORKS:
The damping units in the left and the right fork leg are of different design.
Make sure not to mix them up in case of repair or service works.
01.18.T7.05
Compression adjuster 3
Rebound adjuster 5
Spring 63 / 260
Spring preload 23 mm (0,9 in)
STANDARD-ADJUSTMENT - SHOCK ABSORBER
05.18.T7.81
Compression adjuster 10
Rebound adjuster 12
Spring 4,2 N/mm
Spring preload 6 mm (0,24 in)
Air chamber length 130 mm (5,1 in)
Capacity per fork leg ca 700 ccm
Fork oil SAE5
STANDARD ADJUSTMENT - FORK
Collar screw front axle M10 40 Nm (30 ft.lb)
Brake caliper front M8 Loctite 242 + 25 Nm (18 ft.lb)
Collar nut rear axle M20x1,5 80 Nm (59 ft.lb)
Hex. nut swing arm bolt M14x1,5 100 Nm (74 ft.lb)
Clamping screw top triple clamp M8 23 Nm (17 ft.lb)
Clamping screw bottom triple clamp
M8 18 Nm (13 ft.lb)
Clamping screws fork leg axle passage
M8 10 Nm (7 ft.lb)
Collar screw handlebar clamp M8 20 Nm (15 ft.lb)
Allan head screw handlebar support
M10 40 Nm (30 ft.lb)
Other screws chassis M6 10 Nm (7 ft.lb)
M8 25 Nm (18 ft.lb)
M10 45 Nm (33 ft.lb)
TORQUES