Filter
Top Products
1-24 Copy Functions
Continuous Scan
Scans multiple originals for a single copy job without using the optional
document processor. Divide the original into smaller sets and scan each
set with the document processor. In Continuous Scan mode, you can
continue scanning originals until you press [Scanning finished].
Follow the steps as below to use continuous scan.
1 Press [Function].
2 Press [Continuous Scan].
3 Press [On].
4 Place the original and press the Start key.
Place the next original and press the Start key. Scan the remaining
original pages in the same manner.
When done, press [Scanning finished]. Copying begins.
Proof Copy
Make a test copy of a single set to verify settings before printing the
remaining sets. If a problem is found, avoid wasting paper canceling the
remaining copy job.
Follow the steps below to do a Proof copy job.
1 Press [Function] and then press [T Down].
2 Press [Proof Copy].
3 Press [On].
4 Place the original and press the Start key. The proof copy begins.
5 After printing a single test copy, a confirmation screen will be
displayed, and the copier will remain in standby mode until the job is
approved or cancelled. Check the proof copy.
If it is acceptable, press the Start key. The remaining sets will be
printed.
To change the copy quantity, press [Change Preset] and change the
copy count.
If there is a problem with the copy, press [Cancel] to redo the copy
settings.
Continuous Scan
Off
On
Ba
Copy images from Do
platen for output as o
n
Place originals then press Start key.
Shortcut
Proof Copy
Off
On
Ba
Proof copy outputs on
Ready to Proof Copy.
Shortcut
Outp
u
Chang
e
1 sided
Orig. Page
Top Edge
11×8½"
Job
APS
11×8½" Plain
Count/Set
Monochrome, 1 side
Top
To continue to print, press Start key.
To stop and retry, press Cancel key.
Check proof copy.
Collate
Preset