Filter
Top Products
Page 9 of 12
the outdoor temp, this means that the sensor is either
located too close or too far from the wireless display.
Please adjust the location of the TX61U-IT sensor and
try again. If it fails again, please restart the set up
procedure (see below).
Mounting the Units
The TX61U-IT Sensor
The sensor can be set on a table or mounted onto a
wall using the included screws.
Mounting the Sensor with Screws
1. Remove the mounting bracket
from the TX61U-IT sensor.
2. Place the mounting bracket over
the desired location.
3. Mark the mounting surface with a
pencil through the two screw
holes of the bracket.
4. Screw the mounting bracket onto
the mounting surface. Ensure that the screws are
tight against the bracket.
5. Insert the TX61U-IT sensor into the bracket.
Table Standing and Other Mounting Options
With the mounting bracket installed at the
bottom or on the top of the TX61U-IT
sensor, the user can place it on any flat
surface.
IMPORTANT NOTE: Before permanently
attaching the TX61U-IT sensor base, place
all units in the desired locations to check
that the outdoor temperature readings are
being received. In the event that the signal is not
received, relocate the TX61U-IT sensor (or move them
slightly) to improve the signal reception.
The Wireless Display
The wireless display can be set on a table or mounted
onto a wall.
Table Standing
The two foldout table stands are
located on the bottom of the
back side of the wireless display.
Pull the stands out from the
center to fully extend them.
Wall Mounting
Select a place to mount the wireless
display. Install a mounting screw (not included). Align
the "Hanging Hole" to the mounting screw and ensure
that the wireless display locks down into place before
releasing the wireless display.
fold out legs